November 18, 2026
Failures at the tape overlaps are typical of high voltage WPT coils. This is where partial discharge is usually initiated. ETFE extruded litz is one solution to this situation because the outer jacket is seamless. It has good thermal tarnish for the most part, but there are trade-offs we must consider.
We choose strand size and twist structure based on operating frequency—mostly 85 kHz to 200 kHz. Too-large strands lead to increasing AC losses. Rather few small strands lower fill factor and results in a bigger coil. Twist pitch should be controlled properly so that the currents per all stranded wire are equally distributed.
PDIV is essentially the insulation wall thickness. The higher the voltage, the thinner the thickness of ETFE, but it also increases the outer diameter and stray capacitance. An excess of capacitance changes the resonance and can add additional dielectric loss. We typically examine extremes of electric field at the winding corners because the voltage gets concentrated there.
Reheat can be a practical drawback that must be considered. The solid ETFE jacket impedes thermal dissipation away from the copper. We reserve sufficient thermal margin and confirm resin compatibility if the coil is to be potted.
When you work with this kind of wire, handle it carefully. ETFE is tough; the inner strands of enamel may get nicked if you strip it wrong. It is advised not to subject to sharp bends as it might damage the extrusion layer. In winding, proper creepage distance is also required.
It can even handle moisture and chemicals but the heavy extrusion of ETFE makes the wire stiff This can make automated winding problematic.
So many customers tend to overlook this one: a large amount of customers pay no attention to how the wire itself can affect the electrical performance of a coil.Due to stray capacitance effect the inductance and resonant characteristics change. We always start demonstrating basic prototypes, and test ESR, Inductance,and Capacitance before we define the compensation circuit.
Wound litz made with ETFE extrusion is not an off-the-shelf solution. It offers good high-voltage WPT low partial discharge operation but only with a proper balance of strand construction, insulation thickness, winding layout and thermal design.